spray paint,silicone sealant,lubricant,pu foam

product list: New Products; DISINFECTANT; rubber paint; no more nails; PU sealant; polymer strong adhesive; parquet adhesive; corner adhesive; Silicone Sealant; Spray Paint; pu foam; Car Care Products; PU Sealant

home>>Product>New Products-no more nails

Available size: 300ml
Color: white

No need nails adhesive
No.No nails glue/SP-1016

Overview

Features

Technical data

Directions

This NO MORE MAILS is a synthetic rubber based multipurpose construction adhesive which exhibits excellent strength, flexibility, good temperature resistance and good slump resistance. It is formulated to bond a variety of common construction materials. It has strong initial grab, superior adhesion and will not slump on vertical surfaces.

Where to use

This is a with the benefit of faster application, forming STRONG and LASTING BONDS on most building substrates, including: ●TIMBER ●MDF ●PARTICLEBOARD ●PLASTER BOARD ●STYRENE FOAM ●MASONRY & CONTRETE ●TILES ●CERAMICS ●METALS ●PLASTICS ●RUBBER & GLASS ●SKIRTING ●CORNICES ●ARCHITRAVES

Not recommended for

Wet surface

Grease and dust surfac

Feature	Parameter
Specific weight:	(1.60 +/- 0.05) g/cm3
Skin over time:	10-20 minutes
Volume variation:	(-12 +/- 2) %
E-module 100%:	(0.31 +/- 0.02) N / mm2
Joint movement capability in services:	6% of joint width
Service temperature:	- 25 C to + 80 C

Name

Download

MSDS

Safety precaution

Wash hands after use.

Preparation

Surfaces must be clean, dry and free of frost, grease, dust and other contaminants. To obtain maximum adhesion, surfaces should be flat to provide adequate contact. Painted surfaces must be well cured and free of loose paint. Sand glossy surfaces to a dull finish. Pre-fit all materials before applying adhesive. Cut the tip off the cartridge and screw the nozzle, then apply with silicone gun.

Application

Ensure surfaces are dry and free from oil, grease and dust.

Carefully pierce seal at end of metal tube with reverse end of cap, Attach nozzle to tube and cut to desired opening.

Apply bead along length of joist, stud or batten, on broad flat surfaces apply beads every 40cm.

Bring surfaces together as soon as possible(within the first 10mins)

Fix with sufficient nails, screws or clamping to hold load and achieve contact over the total bond area.

After use, remove nozzle and replace cap.

Allow adhesive to set(min.24 hours) before removing any temporary fastenersor clamping. Use with mechanical fasteners in high stress applications.

Effect

Strong adhesive property to most material, after applying, it can bond the parts very strong, it is non-corrosion, and long life.